Endmill for aluminum steel with good cost performance
Excellent sharpness on aluminum machining.
DLC coated and under cut long shank are also available.
Competitive price with good performance.
Save tool costs
※Price comparison : company A is taken as 100.(each tools are for aluminum steel)
Superior chip evacuation with optimized cutting edges
Excellent surface finish by mirror surface edge.Wide options of length of cut.Competitive price and good cutting performance.
Under cut long shank are also available
Larger diameter than shank diameter to avoid interference.
Workpiece material: Aluminum alloy 7075
Product code: E5D7010022(φ10x3 flutes)
Cutting condition: ap=5mm, ae=10mm, V=200m/min, Ｓ=7,000rpm, fz=0.06mm, F=1,260mm/min
Result：Excellet surface finish with no vibration. Superior chip evacuation.
YG endmill series
For General Steels
For Stainless Steels
For Heat Resistant Alloys
For Pre-Hardened Steels (HRC40~55)
For High h(Hardened Steels (HRC50~70))
For Aluminum, Non-ferrous Metals
Save tool cost with better performance.
Regrinding and Re-coating
Supported by certified factory.